Wednesday, February 1, 2012

Configure your ADSL router for NTC


  1. Open Internet Explorer and then type in the
    address bar.
  2. Put admin in both username & password.
  3. Setup page will open & click on Network & then click on
  4. Default Route Selection – Auto.
  5. Click on Select Current ATM VC Table.
  6. VPI-8
  7. VCI-81
  8. Encapsulation-LLC
  9. Channel Mode-PPPoE
  10. Enable NAPT
  11. Enable IGMP
  12. Type username & password (Provided by NTC).
  13. Type – Continuous
  14. Click on Modify.
  15. Again click on Select Current ATM VC Table.
  16. Click on Save in the bottom of the page
    (red color) if not Press on F11 & then click on Save.
  17. Now you are ready to browse the

No comments:

Post a Comment